Skip to content

How to build the Soma cube throne

The throne uses all seven Soma pieces, 27 cubes in total. Here is one solution: first the finished figure, then the pieces one by one from the floor up, in an order you can follow with real pieces.

LAZBVPT
The finished throne, seen from the front left and above: the front is at the lower right, the left side at the lower left.
  • Vsmall corner
  • LL shape
  • TT shape
  • Zstep (Z shape)
  • Atwist A
  • Btwist B
  • Pbranch

Open in 3D, piece by piece

Opens the solver with this figure. Press "Next" to place one piece at a time, and drag to turn the view.

Step by step

Build in this order from the floor up, lowering each piece from above. Every piece rests on the floor or on pieces already placed.

  1. L

    Step 1 · Place piece L (L shape) on layers 1–2, at the front. It stands upright like a wall running from left to right.

  2. A

    Step 2 · Place piece A (twist A) on layers 1–2, at the back left. Three of its cubes lie on layer 1, and one sticks up onto layer 2.

  3. Z

    Step 3 · Place piece Z (step) on layers 1–2, at the back. It stands upright like a wall running from left to right.

  4. B

    Step 4 · Place piece B (twist B) on layers 1–2, at the front right. Only one cube is on layer 1; the other three lie on layer 2.

  5. V

    Step 5 · Place piece V (small corner) on layers 2–3, at the back left. It stands upright like a wall running from front to back.

  6. P

    Step 6 · Place piece P (branch) on layers 2–3, at the back right. Only one cube is on layer 2; the other three lie on layer 3.

  7. T

    Step 7 · Place piece T (T shape) on layers 4–5, at the back. It stands upright like a wall running from left to right. All 7 pieces are in place and the figure is finished.

Layer by layer, seen from above

Layer 1 is the floor. In each plan the top edge is the back of the figure and the bottom edge is the front.

LLLAABAZZ
layer 1 · floor
LBBVABZZP
layer 2
VPVPP
layer 3
TTT
layer 4
T
layer 5

Tip

Only pieces T and Z can fill the cube at the back of layer 4. Try those there first.

About this figure

Open in 3D, piece by piece